You will need:2 x A4 White Card
14.5cm x 14.5 cm piece of ‘In the pink’ Brazzill Basic card
8.5 x 12 cm piece of Dusky Pink Pearlised Card
8 x 11.5 cm piece of Ivory Pearlised Card
3 mm rose pink satin ribbon
5 mm Green Gingham ribbon
Diamante Stick-on Gems
Zinnia Flower Fairy Stamp Set
Frosted Lace Stickles
Black Solvent Ink pad
Colouring medium of your choice
Tools:
Guillotine/paper trimmer/Craft Knife
Scissors
Double Sided Tape
3d Foam Pads
Glue
Instructions:
1. Stamp the smaller of the fairy stamps 3 times onto plain white card using a solvent ink pad (e.g. Stayzon). Colour the 3 images using the colouring medium of your choice (I’ve used Watercolour pencils). Add stickles to the wings, headband and flower centres. Leave to dry.
2. Using the other piece of white A4 card make a square card blank by scoring down the centre, folding the card in half and trimming it to be approx 15 cm square with your guillotine/paper trimmer or craft knife.
3. Take the Pink Brazill Basics card and add green gingham ribbon to one side, tying the ends into a bow. Add double sided tape to the back of the brazzill card and stick it to the front of your card blank.
4. Cut 3 lots of 9cm lengths of pink satin ribbon and stick them at 3 points (near top, middle and near bottom) across the thinner width of the ivory pearlised card. Tie 2 small knots into 2 more pieces of the ribbon and glue to the top and bottom ribbons on the ivory pearlised card. Stick the ivory pearlised card onto the dusky pink pearlised card. Mount these pieces of card onto the pink brazzil card at an angle.
5. When your stamped images are dry, cut them out in the sections shown in the photograph below.
6. Mount the full image of the fairy onto the ivory pearlised card using 3d foam pads. Add the middle layer and then the top layer with 3d foam pads too.
7. Finally add a stick – on diamante gem to 3 corners of the Brazzill Pink Card (missing the corner nearest the gingham bow). Your card is complete.
Designed & created by Sharon
Posts
0 comments:
Post a Comment