Crafter's Companion Play Time Stamp Projects

For this Project you will need:
Crafter's Companion Cute Companion Stamps~Playtime
Scissors
Black Ink Pad
Tape Pen
Foam Pads
DL Card Blank
White Card~ This is for stamping onto.
Red Card~ Cut at 80 x 190
Craftime Embellishment~ Party Time

Instructions:
* Ink up the stamps you are going to use on this project (Engine, Carriages x 2, Boy Mouse, hat, Elephant and teddy) Stamp these onto white card and colour using your preferred Colouring Medium, I have used Markers.
* Cut out the images, I prefer to leave a small border around the edge, on one of the carriages i have cut along the middle to make it shallower. Now for the fun bit, place the little elephant and teddy in the carriages, stick them to the carriage using a tape pen. Now stick the little hat onto the mouse and place the mouse in the engine, stick using tape pen.
* Stick the red card to the card blank using your tape pen and stamp the sentiment to the top right hand side.
* Using foam pads, stick on your little engine and carriages.
* To finish, stick on your party time embellishments using PVA/wet glue. Your project is complete.

For this project you will need:

Square White Card Blanks~125x125

Crafter Companion Cute Companions~Playtime

Black Ink Pad

Forest Green Card~ Cut to size 115x115

Red Card~ Cut to size 120x120

White Card~ For Stamping images onto

Kanban 'Bling' Stick on Gems

Red Ribbon

Tape Pen

Foam Pads

Scissors

PVA Glue

Craftime Embellishments~Party Time

Preferred Colouring Medium eg. Pencils, Markers, Paint.

Instructions:

* Ink up the stamps that you are going to use on your project and stamp them onto white card (I have used the boy mouse, car and corner balloon border stamped twice) Colour these with your favorite colouring medium (I have used Markers) then cut these out, I prefer to leave a small border around the edge. To get the little Mouse to sit in the car, cut along the dashboard of the car then slide the little mouse image into this.

*Take the red card and attach this to your card blank using your tape pen.

* Stick your cut images to the Green card using foam pads then tie the red ribbon around the green card underneath your images, now stamp the sentiment under the ribbon at the bottom of your green card.

* Using a wet glue stick the Party time embellishments randomly to your card.

* Now stick the green card at an angle on top of the red card on your card blank.

* To finish your card stick the Kanban Bling gems to the corners of your red and green card. Your project is now complete.

Designed & created by Donna

Remember all the above items are available at www.onestopcardcrafts.co.uk...... save up to 30% off all online orders!!!!